How To Service Traction Control And Stabilitrak On 2007 Gmc Acadia
The vehicle has a vehicle stability enhancement system called StabiliTrak. It is an avant-garde calculator controlled system that assists with directional control of the vehicle in hard driving conditions.
StabiliTrak activates when the computer senses a difference between the intended path and the management the vehicle is actually traveling. StabiliTrak selectively applies braking pressure level to the vehicle'southward brakes to assistance steer the vehicle in the intended direction.
StabiliTrak is on automatically whenever the vehicle is started. To assist with directional control of the vehicle, the arrangement should e'er be left on. Trailer Sway Control (TSC) is also on automatically when the vehicle is started. See Trailer Sway Command (TSC) on page 9‑63 for more information.
When the stability control system activates, the Traction Control System (TCS)/StabiliTrak low-cal will flash on the instrument panel. This also occurs when traction control or TSC is activated. A noise may be heard or vibration may be felt in the restriction pedal. This is normal. Go along to steer the vehicle in the intended management.
If there is a trouble detected with StabiliTrak, SERVICE
STABILITRAK is displayed on the Commuter Information Center (DIC) and 
will stay on. Come across Ride Control Organisation Messages on folio five‑30.
When this message is displayed and/or comes on and stays on, the vehicle is safe to bulldoze just the organization is not operational. Driving should be adjusted accordingly.
If comes on and stays on, reset the system by:
ane. Stopping the vehicle.
2. Turning the engine off and waiting 15 seconds.
3. Starting the engine.
If d still comes on and stays on at a speed above 20 km/h (13 mph), come across your dealer for service.
is located on the panel.
Both StabiliTrak and Traction Control can be turned off if needed by pressing and holding until and 
come on the instrument panel. This will also disable the TSC characteristic. When StabiliTrak is turned off, the system volition not assistance with directional control of the vehicle or limit wheel spin. Driving should be adjusted appropriately. Press and release again to turn the system back on.
If cruise control is being used when StabiliTrak activates, the cruise control will automatically undo. Press the cruise command push button to reengage when route conditions allow. See Cruise Control on folio 9‑38 for more information.
Traction Control System (TCS)
The vehicle has a Traction Control System (TCS) that limits wheel spin. On a forepart-wheel-drive vehicle, the system operates if it senses that ane or both of the front wheels are spinning or beginn ...
See also:
Automatic heating and cooling control system
(If installed) Your Hyundai is equipped with an automatic heating and cooling control system controlled by simply setting the desired temperature. TYPE A (Without A.Q.S: Air Quality Organisation) ...
Things you need to know
Operate the system just when it is safe to practise and then. The requirements of national Route Traffic Regulations always utilise. Observation of traffic signs and local traffic regulations always accept pri ...
Bulldoze Belt
Alert: When the engine is running, go on hands, hair, habiliment, tools, etc. abroad from the moving fan and drive belts. Make sure the drive chugalug tension is correct. If the belt is also loose, insuff ...
Source: http://www.c-suvs.com/stabilitrak_system-925.html
Posted by: saundersawareed40.blogspot.com
0 Response to "How To Service Traction Control And Stabilitrak On 2007 Gmc Acadia"
Post a Comment